Abstract

Visible and near infrared imaging techniques for analysing characteristics of torrefied biomass were evaluated for possible use in future online process control. The goal of such a control system is to identify products with the desired properties and reject products outside the specification. Two pushbroom hyperspectral cameras with different wavelength regions and a commercial digital colour camera were evaluated. The hyperspectral cameras, short wave infrared (SWIR) and visible–near infrared (VNIR), covered the ranges of 1000–2500 nm and 400–1000 nm, respectively. The biomass was produced according to an experimental design in a torrefaction pilot plant at different temperatures, residence times, and nitrogen and steam flow rates to obtain a wide range of different characteristics and qualities of torrefied material. Chemical characteristics, heating values and milling energy of the different torrefied materials were analysed or calculated using standardized procedures and were used for calibration. For the hyperspectral images, a principal-component analysis was performed on the absorbance spectra. The score plots and score images were used interactively to separate background, outlier pixels and shading effects from sample signal. Averaged spectra of individual torrefied woodchips were used. Partial least-squares regression was used to relate average spectra to heating values and chemical characteristics of the torrefied biomass. Owing to the small size of the data sets, cross-validation using leave-one-out validation was used for testing the models. The ratio of standard error of prediction to sample standard deviation (RPD) values were used for comparing the imaging techniques. For RGB images, all RPD values were 4 or lower. The RPD values for the VNIR technique were all below 5, while the SWIR images produced RPD values above 5 for eight of the 13 properties. The promising results of the SWIR technique strongly suggested that the torrefied biomass undergoes changes to chemical structures, which are not necessarily manifested as changes to the colour of the material.

© 2014 IM Publications LLP

Spectral characterization and discrimination of synthetic fibers with near-infrared hyperspectral imaging system

Xiaoke Jin, Hafeezullah Memon, Wei Tian, Qinli Yin, Xiaofang Zhan, and Chengyan Zhu
Appl. Opt. 56(12) 3570-3576 (2017)

Visualizing of skin chromophore concentrations by use of RGB images

Izumi Nishidate, Kiyohiro Sasaoka, Testuya Yuasa, Kyuichi Niizeki, Takaaki Maeda, and Yoshihisa Aizu
Opt. Lett. 33(19) 2263-2265 (2008)

Copper concentrate dual-band joint classification using reflectance hyperspectral images in the VIS-NIR and SWIR bands

Franco Rivas, Francisco Pérez, Claudio Sandoval, Ignacio Sanhueza, Benjamín Sepúlveda, Jorge Yañez, and Sergio Torres
Appl. Opt. 62(12) 2970-2977 (2023)

Data-driven imaging of tissue inflammation using RGB-based hyperspectral reconstruction toward personal monitoring of dermatologic health

Taehoon Kim, Michelle A. Visbal-Onufrak, Raymond L. Konger, and Young L. Kim
Biomed. Opt. Express 8(11) 5282-5296 (2017)

Identification of overlapping plastic sheets using short-wavelength infrared hyperspectral imaging

Keisuke Ozawa
Opt. Express 31(8) 12328-12338 (2023)