Abstract
Photoinhibition (PI) mechanisms have been introduced in nanofabrication which allows breaking the diffraction limit by large factors. Donut-shaped laser is usually selected as a depletion beam to reduce linewidth, but the parasitic process has made the results of the experiment less than expected. As a result, the linewidth is difficult to achieve below 50 nm with 780 nm femtosecond and 532 nm continuous-wave lasers. Here, we propose a new, to the best of our knowledge, method based on a center-non-zero (CNZ) depletion laser to further reduce linewidth. By constructing a smaller zone of action under the condition of keeping the maximum depletion intensity constant, a minimum linewidth of 30 nm (λ / 26) was achieved. Two ways to construct CNZ spots were discussed and experimented, and the results show the advantages of our method to reduce the parasitic process to further improve the writing resolution.
© 2023 Optica Publishing Group
Full Article | PDF ArticleMore Like This
Xi Liu, Chenliang Ding, Xiujun Gao, Xiaoming Shen, Mengbo Tang, Zhenyao Yang, Liang Xu, Cuifang Kuang, and Xu Liu
Opt. Lett. 48(16) 4300-4303 (2023)
Richard Wollhofen, Bianca Buchegger, Christine Eder, Jaroslaw Jacak, Johannes Kreutzer, and Thomas A. Klar
Opt. Mater. Express 7(7) 2538-2559 (2017)
Yanping Lan, Juntao Hu, Wenni Ye, Peiqi Zeng, and Yixian Qian
Opt. Lett. 48(3) 775-778 (2023)