Abstract
A method of fabricating replica figured x-ray optics with integral multilayer coatings is presented. With the intact electroforming multilayer process (IEMP) technique, we sputter multilayers onto a reusable superpolished mandrel, electroform nickel over the multilayers, and remove the multilayer-coated nickel shell intact from the mandrel. This approach offers advantages over more traditional, original, and segmented-replica fabrication techniques, including low cost; compatibility with a wide range of mirror designs, diameters, and focal lengths; simple integration with multilayer sputtering processes; and the ability to produce complete shells of revolution. The fabrication of W/Si multilayer-coated 10-cm-diameter conical x-ray mirrors is described, as are reflectivity measurements at 10 and 30 keV. The measured reflectivity of the IEMP multilayers at the 10-keV primary Bragg peak was 17%. Measurements of multiple points on the cone showed multilayer uniformity to within a few percent around the mirror.
© 2003 Optical Society of America
Full Article | PDF ArticleMore Like This
Fred Berendse, Scott M. Owens, Peter J. Serlemitsos, Jack Tueller, Kai-Wing Chan, Yang Soong, Hans Krimm, Wayne H. Baumgartner, Yasushi Ogasaka, Keisuke Tamura, Takashi Okajima, Yuzuru Tawara, Koujun Yamashita, Kazutami Misaki, and Hideyo Kunieda
Appl. Opt. 42(10) 1856-1866 (2003)
Melville P. Ulmer, William R. Purcell, Jane E. A. Loughlin, and Michael P. Kowalski
Appl. Opt. 23(23) 4233-4236 (1984)
David L. Windt, Soizik Donguy, Charles J. Hailey, Jason Koglin, Veijo Honkimaki, Eric Ziegler, Finn E. Christensen, Hubert Chen, Fiona A. Harrison, and William W. Craig
Appl. Opt. 42(13) 2415-2421 (2003)