Abstract

The effect of macrobending on fiber Bragg gratings (FBGs) in standard and specialist use single-mode fibers has been investigated for bend diameters down to 6 mm. The bend dependence of various spectral properties of FBGs, including center wavelength, were found to depend upon fiber type. A maximum centre wavelength shift of 0.39 nm was measured for a FBG written in low bend loss fiber bent to a 6 mm diameter. To investigate the cause of the observed wavelength shift, and the dependence on fiber design, a number of theoretical models have been applied to the problem. The results of modeling suggest that bend-induced changes in mode structure may explain the observed differences between fiber types, while wavefront distortion might be the cause of the general shift to shorter FBG center wavelengths when the bend diameter decreases.

© 2012 IEEE

PDF Article

References

You do not have subscription access to this journal. Citation lists with outbound citation links are available to subscribers only. You may subscribe either as an OSA member, or as an authorized user of your institution.

Contact your librarian or system administrator
or
Login to access OSA Member Subscription

Cited By

You do not have subscription access to this journal. Cited by links are available to subscribers only. You may subscribe either as an OSA member, or as an authorized user of your institution.

Contact your librarian or system administrator
or
Login to access OSA Member Subscription