Abstract

We introduce a procedure to calibrate an inexpensive, commercial camera for optical power measurements. This allows the use of the camera as a very sensitive optical power meter that is able to measure powers down to the femtowatt level. A windowing technique, based on the selection of a region of interest from the total sensor area, is used to maintain a good signal-to-noise ratio over a large range of the measured optical powers. The increase of the exposure time of the camera shifts its detection limit to lower powers. Using this calibration procedure and the windowing technique, we measured 25 fW of optical power with a common complementary metal-oxide-semiconductor camera.

© 2014 Optical Society of America

Virtual camera calibration using optical design software

Anne-Sophie Poulin-Girard, Xavier Dallaire, Simon Thibault, and Denis Laurendeau
Appl. Opt. 53(13) 2822-2827 (2014)

Flame spectra-temperature estimation based on a color imaging camera and a spectral reconstruction technique

Carlos Toro N., Luis Arias P., Sergio Torres, and Daniel Sbarbaro
Appl. Opt. 53(28) 6351-6361 (2014)

Robust, common path, phase shifting interferometer and optical profilometer

Remy Tumbar, Daniel L. Marks, and David J. Brady
Appl. Opt. 47(10) B32-B43 (2008)

Camera-based angular resolved spectroscopy system for spatial measurements of scattered light

Marko Jošt, Janez Krč, and Marko Topič
Appl. Opt. 53(21) 4795-4803 (2014)

Flying spot laser triangulation scanner using lateral synchronization for surface profile precision measurement

Hanlin Zhang, Yongjie Ren, Changjie Liu, and Jigui Zhu
Appl. Opt. 53(20) 4405-4412 (2014)