Abstract

We present the results of a study that identifies a photomultiplier tube (PMT), divider networks, and gating circuitry for use in the current detection mode, in which the specific objectives were to hold variations in both signal gain over a 25-μs gate period and signal linearity up to 20 mA to less than ±0.1%. The study, aimed at optimizing the performance in a nadir-looking airborne UV differential absorption lidar, is sufficiently general to apply to other critical gated or pulsed PMT applications in which performance at the 0.1% level is required. Signal-induced gain increases peculiar to pulsed or gated signals from PMT’s with BeCu dynodes that can have values between 1 and 10% over 25 μs were reduced to less than 0.1% by the use of a 2-in. (5.08-cm)-diameter PMT (EMI 9214) with CsSb dynodes. Compliance with the linearity requirement was achieved for gated signals up to 8 mA at a current gain of ~10⁷ with the EMI 9214 PMT controlled by a resistive divider network with an inverted taper, in which the linearity data showed no tendency toward overlinearity caused by either space charge effects or induced divider-network voltage changes.

© 1995 Optical Society of America

Lidar-signal compression by photomultiplier gain modulation: influence of detector nonlinearity

Michael P. Bristow
Appl. Opt. 37(27) 6468-6479 (1998)

Suppression of afterpulsing in photomultipliers by gating the photocathode

Michael P. Bristow
Appl. Opt. 41(24) 4975-4987 (2002)

Gated photomultiplier response characterization for DIAL measurements

H. Sang Lee, Geary K. Schwemmer, C. Laurence Korb, Mark Dombrowski, and Coorg Prasad
Appl. Opt. 29(22) 3303-3315 (1990)

Signal-induced fluorescence in photomultipliers in differential absorption lidar systems

Yanzeng Zhao
Appl. Opt. 38(21) 4639-4648 (1999)

Expanding the dynamic range of a lidar receiver by the method of dynode-signal collection

Grigorii P. Kokhanenko, Ioganes E. Penner, and Vitalii S. Shamanaev
Appl. Opt. 41(24) 5073-5077 (2002)