Abstract

Planar polyimide light guides can be used for optical detection of humidity. In a phase-matched guide a TE mode and a TM mode of different orders are influenced differently by a humid atmosphere. With crossed polarizers a phase shift induced by the moisture is detectable in the form of an oscillating output signal. For fully cured and thus well-defined and stable fluorinated polyimide light guides a sensitivity curve is presented for the humidity range of 10–75% relative humidity. A special sensitivity is obtained by using a four-layer waveguide arrangement with two layers of polyimide. The shift of the effective mode indices is also measured for each polarization by using a half-integrated interferometer. The results are interpreted in terms of a refractive-index increase that is due to water indiffusion and a swelling process for higher humidities. The measurement in the waveguide interferometer required a moisture-insensitive coating of the reference channel. This was achieved by the use of fluorinated polymers.

© 1993 Optical Society of America

Evaluating polyimides as lightguide materials

Rainer Reuter, Hilmar Franke, and Claudius Feger
Appl. Opt. 27(21) 4565-4571 (1988)

Optical fiber humidity sensor based on the direct response of the polyimide film

Ce Bian, Manli Hu, Ruohui Wang, Tingting Gang, Rongxin Tong, Lisong Zhang, Teng Guo, Xiaobo Liu, and Xueguang Qiao
Appl. Opt. 57(2) 356-361 (2018)

Optical relative humidity sensor with high sensitivity based on a polyimide-coated symmetrical metal-cladding waveguide

Wen Yuan, Xianping Wang, Yiyou Nie, Jun Li, and Minghuang Sang
Appl. Opt. 54(4) 834-838 (2015)

Polar-groups-modified polyimide based on a fiber Bragg grating for relative humidity sensors

Heng Wu, Tengpeng Sun, Jiankun Peng, Jixiang Dai, and Minghong Yang
Appl. Opt. 59(8) 2468-2473 (2020)

Single-mode optical waveguides fabricated from fluorinated polyimides

Junya Kobayashi, Tohru Matsuura, Shigekuni Sasaki, and Tohru Maruno
Appl. Opt. 37(6) 1032-1037 (1998)