Abstract

An electronic timing circuit using a microphone triggering device has been developed for elimination of mechanically induced frequency-jitter in diode laser spectrometers employing closed-cycle refrigerators. Mechanical compressor piston shocks are detected by the microphone and actuate an electronic circuit which ultimately interrupts data acquisition until the mechanical vibrations are completely quenched. In this way, laser sweeps contaminated by compressor frequency-jitter are not co-averaged. Employing this circuit, measured linewidths were in better agreement with that calculated. The importance of eliminating this mechanically induced frequency-jitter when carrying out quantitative diode laser measurements is further discussed.

© 1987 Optical Society of America

Absolute line strengths in ν₄,¹²CH₄: a dual-beam diode laser spectrometer with sweep integration

D. E. Jennings
Appl. Opt. 19(16) 2695-2700 (1980)

Linewidth measurements of tunable diode lasers using heterodyne and etalon techniques

J. Reid, D. T. Cassidy, and R. T. Menzies
Appl. Opt. 21(21) 3961-3965 (1982)

Electrooptic modulation methods for high sensitivity tunable diode laser spectroscopy

David A. Glenar, Donald E. Jennings, and Shacher Nadler
Appl. Opt. 29(15) 2282-2288 (1990)

Tunable diode-laser heterodyne spectrometer for remote observations near 8 μm

D. Glenar, T. Kostiuk, D. E. Jennings, D. Buhl, and M. J. Mumma
Appl. Opt. 21(2) 253-259 (1982)

High sensitivity detection of transient infrared absorption using tunable diode lasers

Paul H. Beckwith, Carl E. Brown, David J. Danagher, Donald R. Smith, and John Reid
Appl. Opt. 26(13) 2643-2649 (1987)